No power to my electric quick attach on CAT 259D

Check your message inbox.

S.Fox said: View attachment 355476 Click to expand... I have the schematic Nige sent you and was looking at it. Noticed there is 2 relays that power the Quick attach that are found on the right wall of what looked like the engine compartment on the pictorial. Would be a good place to check if there was signal entering them as you could swap the two after first marking them to quick check if one has gone bad. There was a breaker on it also I seem to recall. Couple simple things to check. Simon C

Thanks just now go a chance to look at the schematics, and I will look at the relays first and check them out. Hopefully if weather is not to bad be able to look at it this weekend.

looks like both relays are using the same ground and power so it would have to be the relay or the signal to make the coil energize.

Junkyard said: It also won’t work if the auto-level is on the fritz. In a pinch I’ve used a 12v drill battery and some jumpers to run it. Click to expand... Is this the same issue on the B series machines? This may also be my issue.

FYI B and D models have totally different electrical systems. For example the B does not have relays for the quick attach, amongst others.

I’m having the same issue on my 259D, no power at the coupler. I do have power at the switch. If I could bother you for a schematic, I’d be grateful! FTL10502

Check your message inbox.

Nige said: Check your message inbox. Click to expand... Hey im having the same issue with my 239D. A stick ripped both wires out of the actuator and I got a new one but I have power at the switch but nothing at the actuator my serial # is BL900626 thanks for any insight

Check your message inbox.